
WARNING Failure to heed the following warnings could cause damage to
pool equipment or personal injury.
SAFETY INSTRUCTIONS
5
· Chlorinator must be installed and operated as specified.
· Scratching or bending plates in cell housing can reduce cell life.
· Power to the LM2 should be turned off before unplugging the cell connectors to prevent cell damage and low
voltage sparks.
· Keep the cell terminals protected with a light coating of silicone grease to allow for a positive electric
connection. Use of any other type of grease may damage the terminal seals and ‘o’ rings. Do not immerse
these terminals in acid wash solution, and avoid accidental contact with salt water.
· Water above the temperature of 40ºC (104ºF) flowing through the cell can cause plastic cell to discolour.
· Power pack must not be installed directly above any other heat source such as filter, pump or heater. It must be
at least 30 cm (1 foot) from the ground to allow free circulation of air around it. It must not be installed in a
closed box. If the power pack is to be installed on a post, then it must be centrally positioned on a flat panel of
suitable waterproof material at least 24 cm (10 inches) wide and 44 cm (18 inches) high.
· Check the cell frequently to prevent the accumulation of pool debris that for any reason may have by-passed
the pool filter.
· To avoid personal injury when working with pool chemicals, always wear rubber gloves and eye protection and
work in a well-ventilated area. Use caution when choosing a location to open and use chemicals as they may
damage any surface in which they come in contact.
· The addition of certain chemicals can reduce the effectiveness of chlorine. Always make sure that proper
residual chlorine levels are maintained to avoid personal injury.
· This product manufactures chlorine. Individuals with any type of chlorine sensitivity should take the
appropriate precautions to avoid injury or illness.
· Turn device off when backwashing filter.
Kommentare zu diesen Handbüchern