Cloud LM-2 Series Installationshandbuch PDF herunterladen (Seite 10)

INSTALLATION INSTRUCTIONS

5. Connecting to power supply

The LM2 is factory set as a 220 volt unit. To operate at 110V, transfer the brown wire on transformer

to the 110V side. See inside chassis for directions.

Use #12/2 insulated wire and conduit.

Connect the power supply wires to the first two terminals. It does not matter which of the two

terminals but they must be connected to the two load terminals. (Refer to wiring diagram.)

Connect ground wire to ground terminal (fourth terminal). Note: the third terminal is a spare.

Please note:

The power pack must be wired

to the pump switch terminals.

This unit is factory set to be

wired to 220V but can be

converted to 110V. See inside

chassis for directions.

Option A: Wiring to a pump switch or automatic timer

The power pack must be wired to the load side of the pump switch or timer, so that the salt system

is powered only when the pump is powered. Any other type of installation will void the warranty.

Option B: Wiring via an auxiliary relay at the Pool Automation Controller

Using this method the LM2 mains power is connected to an auxiliary relay in the Pool Automation

System. The LM2 unit is switched on and off as determined by the Pool Automation System settings

for the auxiliary relay.

The “Output Setting” and the selection of “Super Chlorinate” must be selected at the LM2 control

panel initially and the LM2 will retain these settings when switched on by the Pool Automation Sys-

tem until they are manually changed.

Circuit Board

Earth/Gound

Connect to

power supply

Spare

110V

220V (factory set)

Fuse

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Keine Kommentare

Cloud LM-2 Series Installationshandbuch Seite 10